Posters
H2 production
ID 2
Bubble behaviors at high-rate water electrolysis
Liang An (The Hong Kong Polytechnic University)
ID 4
Hydrogen Production via Dry Reforming of Methane over Gd-Promoted Ni/SBA-16: Catalyst Design and Process Optimization Using RSM
Ahmed Al-Fatesh (King Saud Univesity)
ID 19
Interlayer-Modulated NiFe-LDH Electrodes with Tunable Interlayer Spacing for Robust and Efficient OER in Water Splitting
Ling-Yu Chang (National Taipei University of Technology)
ID 20
Dual-driven Activation of High-valence States in Prussian Blue Analogues via Graphene-quantum dots and Ozone Induced Surface Restructuring for Hydrogen Evolution
Min-Hsin Yeh (National Taiwan University of Science and Technology)
ID 24
Analysis of preheating strategy and heat transfer mechanism of the MS-SOEC system
Jenn-Kun Kuo (National Sun Yat-sen University)
ID 25
Asymmetric Co-Flow Membraneless Electrolysis for High-Purity Hydrogen Production via Hydrodynamic Bubble Control
Mohammad Torkian (Universite Libre de Bruxelles)
ID 30
Novel metal-organic complexes’ catalysts for sustainable hydrogen production
Rafia Nimal (University of Cambridge)
ID 31
Accelerating Start-Up and Boosting Hydrogen Output through Applied Potential Control in Bench-Scale Membraneless Single-Chamber MECs
MINSOO KIM (Pusan National University)
ID 37
Life Cycle Assessment and Environmental Life Cycle Cost of a Photoelectrolysis Cell for Hydrogen Production
Mauro Giorgianni (Institute of Advanced Technologies for Energy “Nicola Giordano”)
ID 48
Rapid and Facile Fabrication of Electrocatalyst Using Photo-derived Procedure for Hydrogen Evolution
Jung Woo Lee (Pusan National University)
ID 49
Low-carbon Hydrogen and SWCNTs Production Via Plasma Catalytic Pyrolysis
Jafar Fathi (Czech Academy of Sciences)
ID 52
On-demand hydrogen production by ammonia decomposition at low temperatures
Yasushi Sekine (Waseda University)
ID 75
Hydrogen production from aluminum reaction with NaOH/H2O solution: experiments and insights into reaction kinetics
Martina Iaia (University of Modena and Reggio Emilia)
ID 79
PVD-coated interconnects for solid oxide electrolysers
Kun Zhang (University of Birmingham)
H2 embrittlement
ID 15
Hydrogen Embrittlement of Steel in Repurposed Natural Gas Infrastructure: Experimental Insight and Safety Assessment
Klára Kuchťáková (University of Chemistry and Technology Prague)
ID 28
Hydrogen embrittlement: Phase-selective lattice swelling and stress evolution
Veronika Mazanova (Czech Academy of Sciences)
ID 54
Influence of microstructure evolution and precipitation on hydrogen embrittlement in Al0.35CoCrFeNi complex concentrated alloy
Selim Burak Canturk (Slovak Academy of Science)
ID 57
Hydrogen Embrittlement of Cast and Forged Steels for Hydrogen Gas Infrastructure Applications
Hana Jirková (Research and Testing Institute Pilsen)
ID 59
Advanced microscopic techniques for studying hydrogen embrittlement in electrolytically hydrogen-saturated steels
Josef Duliškovič (Research and Testing Institute Pilsen)
H2 Compression & Storage
ID 9
Adhesives and sealants for electrolysers, fuel cells and energy storage devices
Andreas Arlt (WEVO-CHEMIE GmbH)
ID 13
Simulation of the thermal behavior of hydrogen tanks
Senén Moya Sáez (Chemnitz University of Technology)
ID 22
Efficient component development of Mg-based solid-state H2 storage alloys for enhanced hydrogen des-/absorption dynamics driven by machine learning
Wei Xue (EPFL)
ID 40
Potential of the Underground Hydrogen Storage in the Czech Republic: the preliminary study
Katerina Musilova (Czech Geological Survey)
ID 68
Characterisation of hydrocarbon-based proton‑exchange membranes for electrochemical hydrogen compression
Tomáš Jedlička (University of Chemistry and Technology Prague)
H2 Mobility
ID 5
A Prospectus for Low-Carbon Hydrogen Transition in Teesside Valley's Road Transport Sector
Muhammad Shahbaz (Teesside University)
ID 11
Design and validation of a scalable hydrogen refueling station platform with intelligent refueling management
Miguelangel Ocando (H2Vector Energy Technologies S.L.)
ID 34
Didactic Aid – Hydrogen Refueling Station (HRS) Simulator
Vladimír Dynda (APT, spol. s r.o.)
ID 41
Methodology for stakeholders interested in implementing regional hydrogen transport microgrids
Vojtěch Přikryl (Transport research centre)
ID 42
Sampling device for high-pressure hydrogen
Vojtěch Přikryl (APT, spol. s r.o.)
ID 44
Ecosystem for hydrogen dispensing at rates above 60 g H₂/s
Vojtěch Přikryl (APT spol. s r.o.)
ID 53
The Hydrogen Prism for Maritime: Angles for Regulating Hydrogen Fuels in the EU Maritime Sector
Kelsey Pailman (University of Groningen)
ID 56
Mobile hydrogen filling stations
Vít Doleček (Czech Technical University)
ID 58
Fuel Cell Electric Vehicle (FCEV) fire accident: case study of a real scenario
Kateřina Symonová (Technical University of Ostrava)
H2 applications
ID 3
Optimization of green hydrogen electrolyser plant efficiency and required power quality solution
Helton Bezerra (Maschinenfabrik Reinhausen GmbH)
ID 21
Hydrogen based poly-generation for energy communities: a case study.
Giuseppe Baiardo (Institute of Advanced Technologies for Energy “Nicola Giordano”)
ID 23
Hybrid NiMo@CC-GF biocathode enhances hydrogen-mediated microbial electrosynthesis for acetate production from CO2
Jung Rae Kim (Pusan National University)
ID 43
Modulating the surface properties of Pd/C catalysts by liquid-phase reductants for enhanced selectivity in benzaldehyde hydrogenation
Anna Hwang (Korea Institute of Industrial Technology)
ID 47
Ammonia-cracking-integrated gas turbine system utilizing turbine waste heat: a thermodynamic performance analysis
Bimal Bhandari (Pusan National University)
ID 73
Modeling and Analysis of the Cost Breakdown in the Mass Production of a 10 kW Fuel Cell Stack
Miroslav Kludský (ÚJV Řež a.s.)
